PLEASE NOTE:
The majority of the contents in this guide apply to both StudioPlus Spectra AND myStratus Desktop.
In most cases, instructions referring to "Spectra" also apply to myStratus Desktop.
Search:
Contents
:
BookmarkPrint

Home > Digital Workflow > Printing Workflow > Designing Print Layouts
Designing Print Layouts

    
NOTE: This feature is available in the Professional and Enterprise versions of both Spectra and myStratus Desktop.

A Print Layout is used to lay out one image multiple times on a single sheet (e.g., four 4x5 on an 8x10 sheet) during the render/print process. See also: Printing Workflow Overview

Layouts are created with the software's Digital Template Builder

Key Ideas

  • Each node (or "drop zone") of a layout must contain the same image. You cannot mix-and-match images in a layout. If you want to use more than one image, use a Composite Template instead. See also: Designing Composite Templates
  • If the aspect ratio of the image doesn't match a zone on the layout, the software will center crop the image to fit.
  • You can use single images or composite images within a layout.

Designing a Print Layout

  1. Go to Tools > Design Tools > Digital Template Builder.

  2. Open the Print Layouts set from the drop-down list.

  3. If desired, create groups to organize your layouts. To create a new layout group, click New Group on the ribbon.

  4. Click New Template to create a new layout.

  5. Give the layout a name and enter the overall dimensions. Click OK when done.

  6. The new layout template will contain a background layer and one drop zone layer.

  7. Click on the drop zone and use your mouse to drag it to the upper-left corner of your sheet. Now look at the Properties list in the lower-right portion of the screen. The Location of the zone should be "0,0". If it's a little off, manually type in the location to position it in the corner.

    HERE'S A FLASH FOR YOU!

    Click Snap to Grid on the ribbon to make positioning and sizing your drop zones easier!

  8. Now use the Size field (also in the Properties list) to adjust the size of the drop zone to exactly the right dimensions. For example, on a 4x5 sheet, the size of the drop zone should be "4.0,5.0". Your template should look like this:

  9. Add additional drop zones as needed and adjust the Location and Size of each drop zone. In the example of a 4x5 sheet pictured below, the drop zones have the following values:

     Zone Location   Size
     1  0,0 4.0,5.0
     2  4,0 4.0,5.0
     3  0,5 4.0,5.0
     4  4,5 4.0,5.0
  10. Click Save Template to save your layout.

  11. Close the window when finished.

Example Print Layout: 4x5 Sheet

Here's a finished layout template for an 8x10 sheet containing four 4x5s.



Using Print Layouts


See also


Was this information helpful?YesNo

How would you rate this page?